Table of Contents
Advertisement
Electrical Connections
C
Remove house fuse or open circuit
C1
breaker.
Loosen screws for the junction box cover
C2
and rotate out of place or remove the
cover.
Examine the junction box location to
C3
determine the best routing of the conduit,
and select the best available
7/8" diameter knockout. Avoid using
holes in the top of the junction box to
prevent the conduit from interfering
with the back of the range.
Break open the selected knockout by
C4
placing a bladed screwdriver on the
scored opening in the junction box and
striking the screwdriver with a hammer.
(Pliers may be required to complete the
removal of the knockout.)
Cover Rotated From
Box Opening
Position the range in front of the opening,
C5
but slightly to the side, in a manner so
that a person can enter the opening to
wire the range to the house wiring in the
junction box.
Feed wires and conduit through the open
C6
hole and snap the conduit fitting into the
hole. Route the conduit in a manner that
will not interfere with the rear wire cover.
The conduit must be routed below the
wire cover.
Installation Instructions
7/8" Knockout
WARNING:
connection of aluminum house
wiring to copper leads can result in
an electrical hazard or fire. Use only
connectors designed for joining copper to
aluminum and follow the manufacturer's
recommended procedure closely.
GENERAL NOTE FOR ALL WIRE NUT
APPLICATIONS: THE PROPER SIZE WIRE NUT
SHALL BE PLACED OVER THE STRIPPED LEADS
AND THE WIRE NUT TWISTED UNTIL THE WIRE
NUT CAN NOT BE PULLED FROM THE LEADS.
NO CONDUCTOR SHALL BE EXPOSED IN
THE CONNECTION. THE EXCEPTION TO THE
CONDUCTOR BEING EXPOSED IS THE BARE
COPPER GROUND CONNECTION.
BREAKER OR FUSE SIZE
240V
208V
+ NOTE: Check Local Codes for
required breaker size.
6
Improper
40 Amps +
40 Amps +
(Continued on following page)
Advertisement
Table of Contents
