Table of Contents
Advertisement
Standard Installation Instructions
D
Install Stop Screw
D2
These screws prevent the range from
sliding out of position during operation.
Carefully mark the cabinet for the
location of the stop screws. Drill 1/8"
pilot holes into the cabinet, each side of
the range. (Make sure not to drill entirely
through the cabinet wall.) Carefully turn
the shoulder screws into the pilot holes
until they are tight.
Placing the Range into the
D3
Opening
It is suggested that two people lift the
range into place, carefully setting the
side metal flanges under the glass on
the edges of the countertop opening.
The protective channels must be in
place (if supplied) during this operation.
Lift and Slide Range
on Countertop
Range
Installation Instructions
Countertop
Cabinet
Placing the Range into the
D3
Opening (Continued)
Carefully slide the range toward the back of the
opening. Stop pushing the Range when there
is still a 4" gap at the front before flushing the
Range with the countertop.
Remove the Protective Channels
D4
(if provided)
Carefully remove the protective channels
from the sides of the glass cooktop. This
may require a slight lifting of the range to
remove the weight of the range from the
protective channels.
Glass Cooktop
Remove Protective Cover From
Both Sides After Range Is In Cabinet
10
cont.
Countertop
Gap Approx. 4"
Gap Approx. 4"
Protective Cover
(Continued on following page)
Advertisement
Table of Contents
