GE JGSP32 Use And Care Manual page 35

location of the stability bracket which is already
attached to the back of the range. This location
for most installations.
should work
attached to the upper set of holes in the back of
the range. See Fig. A. The upper level set of holes
backsplash is not being used, make sure that them
will interfere with the stability bracket when
1'
Bracket
Optional
; I ! ,
Location
,
Bracket
I : :
i
i' \
i \ !
I , ! '
I
Chain
2. Fasten unc cnd of
the stability chain to @
the fluur or wall with
the long screw and
washer-supplied. See ~~~~er and
screw is going
the base t)f the wall or one of the studs in the base
of the wall. Sce Fig. C. Whether you attach the
is in at Icast 3/4 inch thickness of wood other than
plumbing in the area which the screw could
which will allow the chain to be in line with the
bracket side to aide as much as possible when
attached to the unit. Test to see if the chain is
securely fastened by tugging on the chain.
However, it
, .
\
I
Chain
the screw
that
Chain
L o n g S c r e w ,,
3. Temporarily attach the loose end of the chain
the packaging. See Fig. D.
4. Place the range in the counter cutout leaving just
5. Hook the loose end of the chain onto the br~cket
by slipping the nearest link of the chain into the
is no excess slack in the chain after the chain is
attached to the bracket.
CAUTION: Excessive slack in the chain
A
could allow the range to tip over.
6. Slide the range all the way back into the counter.
Once the range is pushed back in place, there will
be a small amount of slack in the chain. This
is nt)rmal.
NOTE:
If attaching to masonry, you can buy suitable screws
and anchors at hardware stores. Use a m~~sonry drill
to drill the required holes.
If range is removed for cleaning or any other reason,
make sure chain is reattached.
Wall Plate
35