Weider Pro 125 Bench User Manual page 7

6. Note that the bracket on the Backrest Frame (4)
has four sets of oval holes and one set of round
holes. Hold the 15mm x 10mm x 67mm Spacer
(28) between the round holes in the bracket. Insert
an M10 x 88mm Bolt (29) through the bracket and
the Spacer. Tighten an M10 Nylon Locknut (18)
onto the Bolt. Make sure that the Spacer is under
the Main Frame (1).
Insert the Locking Pin (16) through one of the four
sets of oval holes in the bracket on the Backrest
Frame (4) and through the welded tube in the Main
Frame (1) (the welded tube is shown in drawing
5).
7. Attach the Backrest (8) to the brackets on the
Backrest Frame (4) with four M6 x 16mm Screws
(15).
8. Attach a 30mm x 25mm Bumper (26) to the indicat-
ed hole in the Main Frame (1) with a Bumper Screw
(25).
Press a 25mm x 50mm Inner Cap (14) into each
end of the Seat Frame (5).
Note that the Seat Frame (5) has two welded
tubes. "tube A" passes through the Seat Frame
and "tube B" is welded beneath the Seat Frame.
Do not confuse the two tubes in this step.
Align tube A in the Seat Frame (5) with the upper
hole in the indicated bracket on the Main Frame (1).
Attach the Seat Frame to the Main Frame with the
M10 x 95mm Bolt (20) and an M10 Nylon Locknut
(18). Do not overtighten the Nylon Locknut; the
Seat Frame must pivot easily.
Insert the Locking Pin w/Ring (30) through tube B
to prevent the Seat Frame (5) from pivoting.
6
29
16
Adjustment
1
7
8
4
15
8
20
30
5
14
25
7
4
Round
Hole
18
Oval
28
Holes
15
Welded
14
Tube A
Welded
Tube B
18
Bracket
26
1