Weider 9150 User Manual page 14

27. Attach the Backrest (41) to the Front Upright (42)
with two M6 x 73mm Bolts (43) and two M6
Washers (78).
28. Press a 38mm Square Inner Cap (32) into the
end of the Seat Frame (36). Attach the Bumper
(67) to the Seat Frame (36) with the M5 x 20mm
Self-tapping Screw (80).
Insert the M6 x 50mm Carriage Bolt (38) into the
centre hole in the Seat Plate (37). Attach the wide
end of the Seat (13) to the Seat Plate with two
M6 x 16mm Screws (18).
Attach the Seat (13) to the Seat Frame (36) with
the M6 x 50mm Carriage Bolt (38), an M6
Washer (78), and the M6 Nylon Locknut (2).
Attach the other end of the Seat (13) to the Seat
Frame (36) with an M6 x 50mm Bolt (33) and an
M6 Washer (78).
29. Press two 38mm Square Inner Caps (32) into the
ends of the Leg Lever (29).
Lubricate an M10 x 60mm Bolt (7). Attach the Leg
Lever (29) to the Seat Frame (36) with the Bolt
and an M10 Nylon Locknut (21). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot easily.
30. Slide a Pad Tube (28) into the hole in the Leg
Lever (29). Press two 19mm Round Inner Caps
(34) into the ends of the Pad Tube. Slide two
Foam Pads (30) onto the Pad Tube.
Repeat this step with the other Pad Tube (28)
and the Seat Frame (36).
27
43
78
42
43
78
28
13
36
33
29
30
30
34
34
14
41
38
37
18
32
78
67
2
80
7
Lubricate
32
36
21
29
30
28
30
29
36
30
28
32
34
34