Weider 8525 User Manual page 9

11. Note: The 3 1/2" Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Route the Short Cable (58) around the 3 1/2"
Pulley (15) attached to the Press Frame (17).
Make sure that the Cable Trap (66) is turned to
hold the Cable in place and that the Cable is
routed around the Pulley as shown. Tighten
the 3/8" Nylon Locknut (21), 3/8" Washer (9), and
the 3/8" x 3 1/2" Bolt (16).
12. Route the Short Cable (58) around the 3 1/2"
Pulley (15). Attach the Pulley and a Cable Trap
(66) to the upper hole in the Front Upright (42)
with a 3/8" x 3 3/4" Bolt (71), a 3/8" Washer (9),
and a 3/8" Nylon Locknut (21). Make sure that
the Cable Trap is turned to hold the Cable in
place and that the Cable is routed around the
Pulley as shown.
13. Remove the preassembled 3 1/2" Pulley (not
shown) from the Long "U"-bracket (57).
Attach the end of the Short Cable (58) to the
Long "U"-bracket (57) with a 1/4" Nylon Locknut
(2) and a 1/4" Washer (10). See the inset draw-
ing. Do not overtighten the Nylon Locknut; it
should be threaded onto the end of the Cable
so only a couple of threads are showing
above the nut.
14. Note: The 3 1/2" Pulley (15) in this step has
been preassembled. It is shown exploded in
this drawing for clarity.
Locate the Long Cable (23). Route the Long
Cable around the indicated 3 1/2" Pulley (15)
attached to the Top Frame (55). Make sure that
the Cable is between the Pulley and the hook
and that the end of the Cable with the ball is
on the indicated side of the hook. Tighten the
3/8" x 3 3/4" Bolt (71) and the 3/8" Nylon Locknut
(21).
11
21
66
15
58
17
12
13
2
57
14
21
55
Hook
23
15
Ball
9
9
16
42
21
9
58
15
66
71
10
58
57
71
2
10
58