Weider 8525 User Manual page 8

8. Identify the Right Arm (48) and the Left Arm (47)
by the position of the welded bracket on each
Arm.
Lubricate both axles on the Top Frame (55).
Press a 1 3/4" Square Inner Cap (44) into the
lower end of the Left Arm (47). Wet the end of the
Arm with soapy water and slide a 10" Pad (45)
onto it.
Have another person slide the Left Arm (47) onto
the left axle on the Top Frame (55). Note: Be
careful not to confuse the Right Arm (48) with
the Left Arm. Make sure that the upper end of
the Left Arm is behind the indicated bracket
on the Top Frame.
Tap two 1" Retainers (69) and a 1" Round Cover
Cap (70) onto the right axle. Make sure that the
teeth on the Retainers bend toward the Cover
Cap, as shown in the inset drawing.
Attach the Right Arm (48) in the same manner.
Cable Assembly
9. During steps 9 through 20, refer to the CABLE
DIAGRAM on page 18 of this manual to verify
proper cable routing.
Locate the Short Cable (58). Lay the Cable in
the bracket on the Base (4) and under the Press
Frame (17). Attach a 3 1/2" Pulley (15) to the
bracket with a 3/8" x 2" Bolt (12) and a 3/8" Nylon
Locknut (21). Make sure that the end of the
Cable with the ball is on the indicated side of
the bracket.
10. Route the Short Cable (58) around a 3 1/2" Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the lower hole in the Front Upright (42) with a 3/8"
x 3 3/4" Bolt (71), a 3/8" Washer (9), and a 3/8"
Nylon Locknut (21). Make sure that the Cable
Trap is turned to hold the Cable in place and
that the Cable is routed around the Pulley as
shown.
8
55
48
55
69
70
9
17
15
21
58
Bracket
10
8
Bracket
Lubricate
Axle
69
70
44
45
12
4
42
21
9
66
15
71
58
47