19. Remove the indicated 3 1/2" Pulley (15) from the
Top Frame (55).
Route the Long Cable (23) around the 3 1/2"
Pulley (15) and reattach it to the bracket on the
Top Frame (55) with the 3/8" x 2" Bolt (12) and
the 3/8" Nylon Locknut (21). Make sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.
20. Attach the Long Cable (23) to the Small "U"-
bracket (67) with a 1/4" Nylon Locknut (2) and a
1/4" Washer (10). See the inset drawing. Do not
overtighten the Nylon Locknut; it should be
threaded onto the end of the Cable only a
couple of turns, as shown.
Attach the Small "U"-bracket (67) to the Weight
Tube (63) with the 5/16" x 1 3/4" Bolt (72) and a
5/16" Nylon Locknut (3).
Seat Assembly
21. Attach the Backrest (41) to the Front Upright (42)
with two 1/4" x 2 1/2" Screws (43) and two 1/4"
Washers (10).
19
20
23
67
72
63
21
11
55
21
Bracket
15
12
23
23
3
10
2
41
43
10
42
43
10
2
67