Weider 8525 User Manual page 12

22. Press a 1 1/2" Square Inner Cap (32) into the
Seat Frame (36).
Insert the 1/4" x 2" Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two 1/4" x 3/4" Screws
(18).
Insert the 1/4" x 2" Carriage Bolt (38) into the indi-
cated hole in the Seat Frame (36). Tighten a 1/4"
Nylon Locknut (2) with a 1/4" Washer (10) onto
the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4" Washer (10) and the 1/4" x
2" Screw (24).
23. Press a 1 1/2" Square Inner Cap (32) into the Leg
Lever (29).
Lubricate the 5/16" x 2 3/4" Bolt (11). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and a 5/16" Nylon Locknut (3). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot freely.
Insert two 3/8" x 2" Eyebolts (35) into the Leg
Lever (29) from the directions shown. Tighten a
3/8" Nylon Locknut (73) and a 3/8" Washer (9)
onto each Eyebolt.
24. Press two 3/4" Round Inner Cap (34) into the
ends of a 12 1/2" Pad Tube (28). Insert the Pad
Tube into the Seat Frame (36). Slide two 5 1/2"
Pads (30) onto the Pad Tube.
Assemble the other Pad Tube (28) to the Leg
Lever (29) in the same manner.
25. Rest the Seat Frame (36) on the indicated pin in
the Front Upright (42). Attach the Seat Frame to
the Front Upright with a 5/16" x 2 3/4" Carriage
Bolt (14) and the Seat Knob (40).
22
38
37
18
32
23
Lubricate
11
29
9
73
35
24
34
30
29
28
25
12
13
36
10
24
2
3
36
35
73
9
32
36
30
28
40 36
14
42
Pin
34