Housing Assembly - Regency Ceiling Fans Amani Owner's Manual

S H A
WITCH OUSING SSEMBLY
1. With the blade arms attached to the fan, you can attach the switch housing.
2. Loosen two of the three screws located on the mounting hub and remove the third.
3. Feed the light wires through the switch housing.
4. Install the switch housing by aligning the holes in the switch housing to the mounting hub screws. Rotate the switch
housing so the third screw hole comes into alignment and attach the third screw. Tighten all three screws once the third
screw is installed.
5. If no light kit is used, the switch housing cover can be installed. Remove the three screws on the switch housing and
install the cover using the three screws.
Note: If a down light kit is to be used, see (Option) for light installation.
6. Again, if no light kit is to be used, install the accent cover plate. The cover plate simply screws onto the switch
housing cover. Thread the accent cover plate onto the switch housing cover and gently tighten.
Connector
Switch Housing
Cover Plate
9