Pioneer AVIC-X1BT Operation Manual page 138

Message
Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse.
Vibration is detected. Please turn
system power off and check the
installation. After checking, please
re-boot the system and press "OK".
Direction of G sensor is not correct.
Please turn system power off and
check the installation. After check-
ing, please re-boot the system and
press "OK".
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
This function is not available now.
System detected that the vertical
angle of the installation has been
changed. Learning status for Gyro
Sensor has been initialised.
System detected that the vertical
angle of the installation exceeds the
permission level. Please install the
navigation unit correctly.
Route calculation was not possible.
Route calculation was not possible
because the destination is too far.
Route calculation was not possible
because the destination is too near.
Route calculation was not possible
due to traffic regulations.
Route calculation was not possible
because no guidance can be pro-
vided around the destination or the
starting point.
136
When
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
The navigation system is installed in
a place where it may be affected by a
large vibration.
Direction of G sensor is set incor-
rectly.
Abnormal output of Gyrosensor is
detected.
The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
If the mounting angle of the Hide-
away unit has been changed.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Route calculation has failed because
of malfunction of map data, software,
hardware, or disc.
The destination is too far.
The destination or way point(s) are
too close.
• The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the
route calculation is hampered.
The destination, way point(s), or
starting point are in an area where no
road exists (e.g. a mountain) and the
route calculation is impossible.
What to do
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Re-install the Hide-away unit in a
place where the unit will not be
affected by vibration.
See the "Installation Manual" and set
the direction of the Hide-away unit
correctly.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
If the sensor learning status reaches
the Sensor Initialising status or
more, the system is ready to be used.
The system initialises the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
Confirm the installation angle. (The
navigation system must be installed
–
within +30 degrees to 30 degrees
of the horizontal, or within five
degrees of your vehicle's direction of
travel.)
• Change the destination.
• Clean the disc.
• Consult the Pioneer Local dealer if
this message persists.
• Set a destination closer to the start-
ing point.
• Set one or more way points.
Set a destination [and way point(s)]
farther from the starting point.
• Set a destination and way point(s)
outside the CTR if you know where
the restricted area is.
• Try the destination or way point(s)
away from the currently set points
to some extent.
• Drive your vehicle to an unre-
stricted area and reset the destina-
tion and way point(s).
• Set a destination and way point(s)
on roads.
• Reset the destination after you
drive the vehicle to any road.