Table of Contents
Advertisement
Installation
3
Fix the display unit with the screw and
the double-sided tape.
1 Screw
2 Drill a hole of 1.5 mm
# Display unit and the mounting base should be
horizontal at this step. Otherwise, fixing with
screw is impossible.
4
Adjust the angle of the display unit.
1
1 Display unit
2 Hexagonal wrench
5
Route the display cable.
Secure the display cable so that it will not in-
terfere with operation of the vehicle.
Mounting with flush mounting
bracket
Thoroughly wipe off the surface before affixing
the double-sided tape.
Important
This installation method requires specialized
knowledge and skills. For the sake of safety, be
sure to consult your dealer about installation.
1
Detach the dashboard or console panel
where you want to install the display unit.
1
2
2
2
Make a hole in the dashboard or con-
sole as illustrated.
To make a hole, use a cut paper stencil printed
on the contain box.
1
1 Dashboard or console
2 Cut paper stencil
# If the size of the hole is too big, the display
unit may be accidentally detached. In this case, a
traffic accident or injury may result.
# Before drilling any mounting holes, always
check behind where you want to drill the holes.
Do not drill into the gas line, brake line, electrical
wiring or other important parts.
3
Affix the double-sided tape along the
periphery of the behind of the mounting
bracket.
1
1 Double-sided tape
2 Mounting bracket
Section
2
35
En
09
Advertisement
Table of Contents
