GE r08654v-1 Installation Instructions Manual page 17

Installation Instructions
Preparing for the Bottom
C3
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim
as a template,
mark the center
of each slot
(two total) where
the mounting holes
will be drilled.
c. Remove the trim.
d. Drill pilot holes into
the center of each
template mark.
For 27" (68.6 cm)
models with Lower
Trim in Position,
Mark (2) Mounting
Hole Locations
here
*
For 30" (76.2 cm)
* Remove
models with
Lower Trim
Lower Trim in
Before
Position, Mark
Pre-drilling
(2) Mounting
Mounting
Hole Locations
Holes
here
Installing the Metal
C4
Bottom Trim
a. Place the bottom metal trim centered over
the pre-drilled mounting holes. Tape the
edges of the trim down to maintain the
alignment.
b. Using two trim screws provided, secure
the bottom trim to the bottom edge of the
cabinet.
Trim Screw Locations for
27" (68.6 cm) models with
Lower Trim
Side
Trim
IMPORTANT: If this unit is ever
removed from the cabinet or the oven
is ever pulled out for service, the trim
must be removed first or damage to
the trim will occur.
17
Side
Trim
Metal Lower Trim
Trim Screw Locations for
30" (76.2 cm) models with
Lower Trim