Specifications - Tripp Lite PowerVerter APSX3024SW Specification Sheet

OverPower output supports longer duration overloads to 150% for up to 60 seconds
3-stage, selectable 23/90 amp battery charger with adjustable settings for wet/gel battery types
3-position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to
maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings
Set of 6 front panel LEDs display continuous status information
Set of 4 dip switches support AC input selection of 230V, selectable 50 /60Hz frequency, and selectable full or half cycle transfer times
Set of 4 dip switches support wet/gel battery charging profiles, adjustable 260/270V (230V) high voltage auto transfer during overvoltages
and selectable 150/60V / 170/180V (230V) AC low voltage auto transfer during brownouts
Set of 4 additional dip switches support battery equalization program and battery charger low / high settings
Automatic overload and thermal (overheating) shutoff
Front panel remote control connector enables remote off/on switching (APSRM4 sold separately)
Load sensing control dial enables adjustable load threshold required to automatically turn the inverter on and off in DC mode as load
conditions change
Automatic Generator Starter jack enables user configuration of automatic generator start-up as inverter batteries drop to 23.0 VDC and
generator shutoff as inverter batteries are recharged to 28.2 VDC.
Remote battery temperature sensing connection function prolongs battery life by adjusting the charge float voltage level based on battery
temperature

Specifications

OVERVIEW
Intended Application Emergency Home Power
OUTPUT
Frequency 50 / 60 Hz
compatibility
Output watts 3000
Continuous output 3000
capacity (watts)
Peak output capacity 6000
(watts)
Output nominal 230V
voltage
Output voltage LINE POWER (AC): Maintains 230V nominal sine wave output from line power source. INVERTER POWER (AC):
regulation Maintains sine wave output voltage of 230 VAC (+/-5%).
Output frequency 50/60 Hz (+/- 0.3 Hz)
regulation
Outlet quantity / type Hardwire
INPUT
Nominal Input 230V AC
Voltage(s) Supported
Recommended DC INPUT: Requires 24VDC input source capable of delivering 145A for the required duration (when used at full
Electrical Service continuous capacity - DC requirements increase during OverPower and DoubleBoost operation).
Maximum Input 28
Amps (A)
Input connection type DC INPUT: Set of DC bolt-down terminals. AC INPUT: Hardwire via built in terminal strip with cover plate
Voltage compatibility 230
(VAC)
Voltage compatibility 24
(VDC)
BATTERY