To Set The Clock; Power Failure - GE JGRS14 Use And Care Manual

OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the automatic oven timing functions to work properly.
The time of day clock cannot be changed during Delay Start. (It can be
changed during a regular bake or broil operation.)

To Set the Clock

1. Press CLOCK.
CLOCK
2. Press the HOUR and MIN + or –
pads to set the time of day.
HOUR
MIN
Timer
You may program the timer to time cooking or other
household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
How to Set the Timer
1. Press KITCHEN TIMER ON/OFF.
KITCHEN
TIMER
ON OFF
2. Press the HOUR and MIN + or –
pads until the amount of time you
HOUR
MIN
want shows in the display.
If you make a mistake, press
KITCHEN TIMER ON/OFF
and begin again.

Power Failure

If a flashing time of day is in the display, you have
experienced a power failure. Reset the clock.
3. Press START. This enters the time and
starts the clock.
START
To check the time of day when the display is
showing other information, simply press CLOCK.
The time of day shows until another pad is pressed.
When the timer reaches " :00," the control will beep
3 times followed by one beep every 6 seconds until
KITCHEN TIMER ON/OFF is pressed.
The 6 second tone can be canceled by following the
steps in the Special Features of Your Oven Control
section under Tones at the End of a Timed Cycle.
3. Press START.
START After pressing START, "SET" disappears;
this tells you the time is counting down,
although the display does not change until
one minute has passed.
4. When time is up, the oven control signals
KITCHEN
TIMER until you press KITCHEN TIMER ON/OFF.
ON OFF
Display then shows the time of day.
NOTE: The minute timer is independent of all the
other functions and it does not control the oven.
The CLEAR/OFF pad does not affect the timer.
To reset the clock, press CLOCK. Enter the correct
time of day by pressing the HOUR and MIN + or –
pads. Press START.
(continued next page)
7