GE JGRS14 Use And Care Manual page 25

PROBLEM
"F–AND A NUMBER
OR LETTER" FLASH
IN THE DISPLAY
CONTROL SIGNALS
AFTER ENTERING
COOKING TIME OR
DELAY START TIME
DISPLAY GOES BLANK
DISPLAY FLASHES
UNABLE TO GET THE
DISPLAY TO SHOW "SF"
CLOCK AND TIMER
DO NOT WORK
OVEN LIGHT DOES
NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST OR BAKE
PROPERLY
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
• This is reminding you to press BAKE and then enter a temperature.
• This is reminding you to enter a bake temperature after having pressed BAKE.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• Power failure. Reset the clock.
• BAKE and BROIL HI/LO must be pressed at the same time and held for
2 seconds.
• Check for power outage.
• The light bulb is loose or defective. Tighten or replace.
• The pad operating the oven light is broken. Call for service.
• The oven controls are not properly set. See the Broiling section.
• Improper shelf position being used.
• Food is being cooked on a hot pan.
• Cookware is not suited for broiling.
• The oven door and/or the broiler compartment door not closed.
• Aluminum foil used on the broiler pan grid has not been fitted properly
and slit as recommended.
• The oven controls are not properly set. See the Baking or Roasting section.
• Shelf position is not correct.
• Incorrect cookware or cookware of improper size is being used.
• Oven thermostat needs adjustment. See the Adjust the Oven Thermostat—
Do It Yourself section.
(continued next page)
25