GE EPM 7300 Installation Manual page 96

Feature
LINE Buttons
Panel Display
Lights
Page Value
1
2
3
1 4
5
6
7
8
1
2
3-12
2 13
14-17
18
19
88
Function
Rotate among parameters within a page. Certain configurations
or meter values may prevent display of all parameters within a
page. The parameters in each page are listed in the table below.
Display animation that shows the status of the 269 Plus relay. If
a trip or alarm has occurred, auxiliary relay 1 or 2 is active. If the
meter fails its self-test, the dark red square to the left of the label
appears bright red.
Table 10. 269+ Faceplate animated functions.
The following table lists the pages that can be accessed with the PAGE buttons, with
the parameters available in each page that can be accessed with the LINE buttons.
Text Displayed
PAGE 1: ACTUAL VALUES
PHASE CURRENT DATA
I1=xxx I2=xxx
I3=xxx (AMPS)---
I(3 Ph avg.)=xxx AMPS
Max Stator RTD=xxx C
UNBALANCE RATIO (In/Ip)
U/B=xx PERCENT
GROUND FAULT CURRENT
G/F=xxx.0 AMPS
ST/HR TIMERS (MIN)
xx xx xx xx xx
TIME
BETWEEN STARTS
TIMER = xxx MIN
END OF PAGE ONE
ACTUAL VALUES
PAGE 2: ACTUAL VALUES
RTD TEMPERATURE DATA
HOTTEST STATOR RTD
RTD #xx = xxx
RTD TEMPERATURE
RTD # xx = xxx
MAX STATOR SINCE LAST
ACCESS: RTD #x = xxx DEGREES C
MAXIMUM RTD #x TEMP SINCE
LAST ACCESS: xxx DEGREES C
CLEAR LAST ACCESS DATA?
NO
END OF PAGE TWO
ACTUAL VALUES
Description
Page header
Phase current in amps; --- or RUN based on
motor status
Average phase current
Hottest stator temperature
Units = *.1 if G/F CT
ratio = 2000:1
Starts per hour
Page footer
Page header
Displays temperatures of RTDs #1-10
Displays #7-10 max
Press STORE to clear; message changes to
YES
Page footer
PMCS Interface Toolkit