Replacing An Auxiliary Light Bulb; Supporting The Motorcycle - Yamaha WR250X Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
1
3
1. License plate light unit
2. License plate light bulb socket
4
3. Remove the burnt-out bulb by pull-
ing it out.
5
4. Insert a new bulb into the socket.
5. Install the socket (together with the
6
bulb) by pushing it in.
6. Install the license plate light unit by
7
installing the screws.
8
9
Replacing an auxiliary light
bulb
If the auxiliary light bulb burns out, re-
2
place it as follows.
1. Remove the headlight unit. (See
page 6-33.)
2. Remove the auxiliary light socket
(together with the bulb) by pulling it
out.
1
1. Auxiliary light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
gether with the bulb) by pushing it
in.
6. Install the headlight unit.
6-36
EAU45222

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
EAU24350