Clutch Lever - Yamaha WR250R Owner's Manual

Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch " /
Set this switch to " " before starting
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
INSTRUMENT AND CONTROL FUNCTIONS
EAU12400
Start switch "
Push this switch to crank the engine
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
EAU12460 gine.
"
The engine trouble warning light will
". When re- come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
EAU12500
EAU12660
"
" to
EAU12711
"

Clutch lever

EAU41700
1. Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the handle-
bar grip. To engage the clutch, release
the lever. The lever should be pulled
rapidly and released slowly for smooth
clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-19.)
3-9
EAU12820
1
3