Tail/Brake Light; Replacing A Turn Signal Light Bulb - Yamaha WR250R Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Tail/brake light

This model is equipped with an LED-
type tail/brake light.
If the tail/brake light does not come on,
have a Yamaha dealer check it.
6
EAU24181
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1. Screw
2. Turn signal light lens
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
6-35
EAU24204
1. Turn signal light bulb
2
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
1
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
1
[ECA11191]