For Vigor2925; For Vigor2925N - Draytek Vigor 2925 Series User Manual

1 . 2 . 2 F o r V i g o r 2 9
1 . 2 . 2 F o r V i g o r 2 9
LED
ACT (Activity)
USB
WLAN
WAN1~WAN2
VPN
QoS
WCF
DMZ
LED on Connector
Left
WAN1~
LED
WAN2
Right
LED
Left
LAN1~
LED
LAN5
Right
LED
2 5 n
2 5 n
Status
Blinking
Off
On
Blinking
On
Blinking
On
Off
Blinking
On
On
On
On
Off
Blinking
On
Off
Blinking
On
Off
On
Off
Blinking
On
Off
Explanation
The router is powered on and running normally.
The router is powered off.
USB device is connected and ready for use.
The data is transmitting.
Wireless access point is ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The VPN tunnel is active.
The QoS function is active.
The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
The DMZ function is enabled.
The DMZ function is disabled.
The data is transmitting.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
5 Vigor2925 Series User's Guide