Install Rails, Vent Deflectors, And Bottom Duct - Jenn-Air JMC3415ES Installation Instructions Manual

IMPORTANT: The flanges of duct 5 go under duct 4. The front
edge of the duct should be flush with the microwave oven itself
and not the door.
Correct
Install Rails, Vent Deflectors,
and Bottom Duct
1. Mark vertical line 1Z\v" (3.2 cm) in on left side of cabinet.
Verify line is level.
1 / " (3.2 cm)
1
4
2. Make sure notch is at bottom of rail. Position the rail marked
L on the left side of the cabinet with the bottom edge resting
on the cabinet floor. Verify rail is 1Z\v" back from the face
of the cabinet before proceeding. Drill pilot holes. Attach
mounting rail using 4 #8-14 x Z\x" screws.
NOTE: Drive screws in the center of the holes in the
mounting rail.
Notches
Left rail
Mounting rail
Incorrect
Right rail
3. Repeat steps 1 and 2 on right side of cabinet. Use the
following chart and illustration to measure the distance
between center of mounting rail holes. Use shims if
measured distance is incorrect.
27" (68.6 CM)
INSTALLATION
26Z\v" (66.7 cm)
4. Remove protective film from vent deflectors.
5. Position 1 of the vent deflectors in the cabinet, flush with
the top front edge of the opening. Drill pilot holes; then,
fasten deflector with 3 #8-14 x Z\x" screws.
Top vent
deflector
6. Center bottom duct in cabinet so that each side of duct is
the same distance from the side walls and front of duct is
M\," (2.2 cm) from front of opening.
7. Mark 4 holes on bottom duct for reference.
Pilot holes
Pilot Holes
8. Remove bottom duct from cabinet and drill pilot holes (2 per
side) using marks made in Step 7.
9. Center bottom duct in cabinet, line-up with drilled pilot holes,
and insert 4 #8-14 x Z\x" screws.
30" (76.2 CM)
INSTALLATION
29Z\v" (74.3 cm)
Pilot holes
Pilot Holes
/ "
7
8
(2.2 cm)
7