Documentation Feedback - HP Integrity Superdome 2 16-socket Release Note

Hp smart update manager 6.0.1 release notes (ed. 2)

Hide thumbs Also See for Integrity Superdome 2 16-socket:

HP SUM does not display the Force button for components to be updated on nodes

running Red Hat Enterprise Linux 5.10

Suggested Action: The work around for this issue is to manually reinstall the RPM outside of HP SUM.

This issue will be fixed in a future version of HP SUM.

HP SUM displays "Update returned an error" when deploying the HP Fibre Channel

Enablement Kit for Linux

Suggested Action: View the update log. If you see the error Enablement kit is not supported

for the installed driver version, use the following instructions to work around this issue:

Install HBA drivers before installing the Enablement kit.

Make sure the driver and Enablement kit version match.

This known issue will be resolved in a future version of HP SUM.

HP SUM displays the error "Unable to start hpsumservice service on node" when it tries

to access a remote node

Suggested Action: Due to network security settings, HP SUM cannot start the HP SUM engine on the

remote node. Run HP SUM locally on the node.

HP SUM cannot create a session on a remote node

Suggested Action: Do not use special characters in passwords on remote nodes. This issue will be

resolved in a future version of HP SUM.

HP SUM stops working when it deploys updates to a Cisco switch

Suggested Action: There is no work around. This issue will be resolved in a future version of HP SUM.

HP SUM input file mode does not apply the LOCALACCESS-ENABLED and

LOCALACCESS-TYPE configuration parameters to System Management Homepage

Suggested Action: Use HP SUM in GUI mode to configure SMH components.

HP SUM requires minimum versions of VC and OA to support HP Integrity nodes

Suggested Action: Verify that HP Integrity i2 OA versions are 3.30 and VC version 3.6, and HP Integrity

i4 servers are OA version 3.60 and VC version 3.70.

HP SUM displays the iLO firmware version as 0.0.0 for Linux nodes

Suggested Action: Make sure that the CHIF driver is installed so HP SUM can detect the correct iLO

firmware version. This applies to iLO2, iLO3, and iLO4.

Documentation feedback

HP is committed to providing documentation that meets your needs. To help us improve the

documentation, send any errors, suggestions, or comments to Documentation Feedback

(docsfeedback@hp.com). Include the document title and part number, version number, or the URL when

submitting your feedback.

Documentation feedback