Replacing Cd-Rom Or Cd+Rw/Dvd Drives - HP Carrier-grade cc2300 Product Manual

The hard drive bays are designed to accept 15,000 RPM (and below) hard drives that consume up to
18 Watts of power.
Figure 11-3. Hard Drive Bays
Hard Drive Tray
Each hard drive used in the server must be mounted to a drive tray using four screws inserted into the
bottom of the drive as shown in Figure 11-4.
Figure 11-4. Hard Drive Tray

Replacing CD-ROM OR CD+RW/DVD Drives

The peripheral bay supports either CD-ROM or CD+RW/DVD drive carrier assembly. These items are
supplied in carrier assemblies that can be inserted into the server. The blind-mate carrier assembly can be
inserted or removed when server power is off. After the drive carrier assembly is installed into the server, a
horizontal handle is used to secure it to the chassis.
CD-ROM, and CD+RW/DVD drives are not hot-swappable. Serious damage can result if the
CAUTION
drive is removed when the server is powered on.
NOTE Disconnect power from server before replacing the CD-ROM drives.
Chapter 9
1
2
TP131
TP130
93