Figure 11-14.
Installing Memory
1B
2B
3B
1A
2A
3A
TP123
Reprogramming the SDR
If you have changed the memory configuration, rewrite the SDR as follows:
1. Boot the system from the HP Server cc3310 Information Diagnostics and Utilities Resource CD.
2. After the server has booted, select Load Configuration Wizard.
3. When the wizard begins, press Continue.
4. Select Server Configuration Wizard and Continue.
5. Select run wizard and Continue.
6. Select Load SDRs only on to this server and Continue.
7. Set the date and time and select Continue.
8. Select Update just the SDR repository and Continue.
9. Select Yes – Activate BMC TAM and Continue.
10. Choose the desired LED configuration and select Continue.
11. Save the configuration to disk and select Continue.
12. Select OK to program SDRs.
13. Observe that the server reboots when the SDR repository has been reprogrammed.
Replacing the Back-up Battery
The lithium battery on the server board powers the real time clock (RTC) in the absence of AC power. When
the battery starts to weaken, it loses voltage, and the server settings stored in CMOS RAM in the RTC (for
Chapter 9
105