Configuration Example; Network Requirements - HP 6125XLG Configuration Manual

Step
8. Create a QoS policy and
enter QoS policy view.
9. Associate the traffic class
with the traffic behavior in
the QoS policy.
10. Return to system view.
11. Apply the QoS policy.
12. (Optional.) Display traffic
redirecting configuration
information.

Configuration example

Network requirements

As shown in
• Device A is connected to Device B through two links. At the same time, Device A and Device B are
each connected to other devices.
Ten-GigabitEthernet 1/1/6 of Device A and Ten-GigabitEthernet 1/1/6 of Device B belong to
•
VLAN 200.
Ten-GigabitEthernet 1/1/7 of Device A and Ten-GigabitEthernet 1/1/7 of Device B belong to
•
VLAN 201.
On Device A, the IP address of VLAN-interface 200 is 200.1.1.1/24, and that of VLAN-interface
•
201 is 201.1.1.1/24.
On Device B, the IP address of VLAN-interface 200 is 200.1.1.2/24, and that of VLAN-interface
•
201 is 201.1.1.2/24.
Configure the actions of redirecting traffic to an interface so that:
Packets with source IP address 2.1.1.1 received on Ten-GigabitEthernet 1/0/1 of Device A are
•
forwarded to Ten-GigabitEthernet 1/0/2.
• Packets with source IP address 2.1.1.2 received on Ten-GigabitEthernet 1/0/1 of Device A are
forwarded to Ten-GigabitEthernet 1/0/3.
Other packets received on Ten-GigabitEthernet 1/0/1 of Device A are forwarded according to the
•
routing table.
Command
qos policy policy-name
classifier classifier-name behavior
behavior-name
quit
•
•
•
display traffic behavior user-defined
[ behavior-name ]
Figure 20:
Applying the QoS policy to an interface
Applying the QoS policy to a VLAN
Applying the QoS policy globally
71
Remarks
By default, no QoS policy
exists.
By default, no
class-behavior
association is configured
for a QoS policy.
N/A
Choose one of the
application destinations
as needed.
By default, a QoS policy
is not applied.
Available in any view.