Opening The Display; Turning On The Power - Toshiba Satellite R20 User Manual

Opening the display

The computer's LCD display panel can be opened in a wide range of
angles for optimal viewing.
1. Push the display latch on the front of the computer to unlatch the
display panel.
2. While holding down the palm rest with one hand so that the main body
is not raised, lift the panel slowly. Adjust the angle of the panel to
provide optimal clarity.
Use reasonable care when opening and closing the LCD display panel.
Opening it vigorously or slamming it shut could damage the computer.

Turning on the power

This section describes how to turn on the power.
The Power button LED indicates the status. Refer to the
section in Chapter 6, Power and Power-Up Modes.
■
After you turn on the power for the first time, do not turn it off until you
have set up the operating system. Refer to the section
the first
■
If the USB floppy disk drive is connected, make sure it is empty. If a
floppy disk is in the drive, press the eject button and remove the floppy
disk.
1. Open the computer's LCD display panel.
User's Manual
LCD display panel
Figure 1-6 Opening the LCD display panel
time.
Getting Started
Display latch
Power indicators
Starting up for
1-8