Turn On The Power; Adjust The Volume; Connect The Pedals - Generalmusic 271221 Owner's Manual

Note: better results are obtained
by adjusting the volume of the
mixer or amplifier controls rather
than lowering the volume of the
instrument.
(All Generalmusic control pedals
are optional accessories).

Turn on the power

The power switch is located on left side of the rear panel (when
sitting in front of the keyboard).
Turn the power on only after all the connections to other equip-
ment (amplifiers, Midi devices, etc.) have been made.
After a short scanning period, the display will appear showing
the last used mode (Sound, Performance, Drawbar, etc.).
The various modes available are explained afterwards.

Adjust the volume

Adjust the general volume of the instrument with the Master pan-
el slider.
If you are using headphones, you should find that about three
quarter volume is a comfortable listening level.

Connect the pedals

There are four rear panel PEDALS jacks marked Volume, 1, 2
and Damper which accept control pedals.
The Volume jack is a non-programmable port for a standard Vol-
ume Pedal. The remaining three jacks (Damper, 1, 2) are fully
editable although their functions have been pre-set at the facto-
ry.
The default configuration of the pedals is as follows:
Ped1 =
Ped2 =
Damper =
Volume =
Your pedals settings can either be stored with each performance
or they can be "locked" so that their functions are global.
Expression
Start/Stop
Damper (sustain)
Volume
Setting-up 7