Battery Installation - Craftsman 82344 Owner's Manual

BATTERY INSTALLATION

WARNING: To avoid electric shock, disconnect the test
leads from any source of voltage before removing the
battery/fuse cover.
1. Disconnect the test leads from the meter.
2. Remove the rubber holster (if in place).
3. Remove the two screws securing the rear cover using a
Phillips head screwdriver.
4. Lift the cover off and replace the batteries observing the
correct polarity.
5. Insert the new batteries into the battery holder.
6. Replace the rear cover and secure with the screws.
WARNING: To avoid electric shock, do not operate the meter
until the battery cover is in place and fastened securely.
NOTE: If your meter does not work properly, check the fuses and
batteries to make sure that they are still good and that they are
properly inserted.
10