Jet JSM-6100v Quick Manual

Specifications

Stock Number ................................................................... JSM-6100
Belt Size (in.) ......................................................................... 3/8 x 13
Noise Level (dB) ............................................................................ 80
Horsepower (HP) .......................................................................... 1/2
Free Speed (RPM) ................................................................. 20,000
Surface Feet per Minute (SFPM) ............................................... 4,328
Required Air Pressure (PSI) ........................................................... 90
Average Air Consumption (CFM) ...................................................... 9
Air Inlet (in.) .......................................................................... 1/4 NPT
Air Hose Inside Diameter (in.) ....................................................... 3/8
Overall Length Folded (in.) ............................................................... 8
Overall Length Open (in.) ......................................................... 12-3/4
2
Vibration Value (m/s ) ................................................................... 1.3
Weight (lbs) ............................................................................... 1-7/8
The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, Walter Meier
(Manufacturing) Inc., reserves the right to change specifications at any time and without prior notice, without incurring obligations.
1. Read and understand the entire contents of this manual before attempting operation.
2. Never operate a belt sander without proper eye and face protection.
3. Do not operate sander while wearing gloves, loose clothing, jewelry or anything that may get caught in a rotating belt.
Long hair must be contained.
4. Wear ear protectors (plugs or muffs) during extended periods of operation.
5. Do not operate sander over 100 PSI.
6. Do not operate sander without the silencer (muffler) installed.
7. Keep hands and fingers away from sanding belt.
8. Disconnect sander from air source before making repairs, adjustments or belt changes.
9. Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known
to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•
Lead from lead based paint.
•
Crystalline silica from bricks, cement and other masonry products.
•
Arsenic and chromium from chemically treated lumber.
Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these
chemicals, work in a well-ventilated area and work with approved safety equipment, such as face or dust masks that are
specifically designed to filter out microscopic particles.
10. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not
designed. The right tool will do the job better and more safely.
11. Use recommended accessories; improper accessories may be hazardous.
12. Don't use in dangerous environment. Don't use power tools in damp or wet location, or expose them to rain. Keep work
area well lighted.
13. Failure to comply with all of the above warnings may lead to serious injury.
WALTER MEIER (Manufacturing), Inc.
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.waltermeier.com
JSM-6100 Belt Sander
Stock No. JSM-6100

Safety warnings

Copyright © 2013 Walter Meier (Manufacturing), Inc.
1
Part No. M-JSM-6100
Revision A1 08/2013