Finisher Control Board, Bracket and Shield
1.
Remove the rear cover, see page 11-17.
2.
Remove 8 screws and loosen the two bottom screws.
3.
Remove finisher control board shield.
4.
Undo all the connectors.
5.
Remove 2 screws on the left.
6.
Loosen 1 screw on the right.
7.
Undo one connector.
8.
Loosen the outer screws located at the bottom of the finisher control board cover.
9.
Remove the 8 remaining cover screws.
11-23