Fx Port Duplex Settings Sw5 Sw6; Factory Default Settings - KTI Networks KCD-302 Series Installation Manual

3.1.3 FX Port Duplex Settings SW5 SW6

This settings are used to set the duplex mode of the FX1 port and FX2
port individually. It is recommended to use full duplex mode for FX con-
nection unless its link partner is a fixed half duplex device. Half duplex
mode will shorten the connection distance. The following table lists the
maximum MMF cable length connecting to different devices:
Link Partner of FX Port
Network card half-duplex fiber port
Network card full-duplex fiber port
Class I hub half-duplex fiber port
2 Class II hub half-duplex fiber port
Switched half-duplex fiber port
Switched half-duplex fiber port
Note: For SMF connection, be sure the link partner is a full duplex
device and set SW5 SW6 to full duplex mode for the FX ports.

3.1.4 Factory Default Settings

The factory default settings are as follows:
SW1 OFF
SW2 OFF
SW3 OFF
SW4 OFF
SW5 OFF
SW6 OFF
TP port mode - auto-negotiation
TP port - full duplex
TP port - 100Mbps
Enable IEEE 802.3x flow control function
FX1 port - full duplex
FX2 port - full duplex
Distance (MMF cable)
-28-
400 m
2 km
160 m
112 m
400 m
2 km