KitchenAid KSRF42DT Installation Instructions Manual page 11

rn
I
Ipi I j
7 Remove end cap from
Em
miscellaneous parts bag
' and insert into top of
door handle. If you wish to change
the door handle insert, slide insert
trim into handle. See Custom panel
and insert dimensions for exact
sizes to cut custom inserts. Insert
end cap into top of door handle.
Replace refrigerator door handle.
Repeat Steps IO and
11
for the freezer door.
-1 R
/13j
emove two nuts from
one end of the top panel
q
frame. Remove end
piece. Slide decorative panel into
panel frame. Replace end piece
using nuts
Check that
top grille is aligned with
top trim on cabinet. Use
ten screws to tighten top grille frame
to refrigerator. Check that the power
switch is in the "ON" position.
Attach top grille decorative panel
assembly to the keyhole bracket on
the frame and pull down to secure.
If the top grille decorative panel
does not fit evenly within frame, the
keyhole bracket can be moved side
to side by adjusting the bracket
screws or the decorative panel
bracket can be moved up or down
by adjusting the decorator panel
bracket nuts.
Personal Injury Hazard
Reinstall set screws after
door swing is set.
Failure to so could result in
personal injury.
El
Check that doors can
m
open freely. If not, the
door stops or hinges
can be adjusted.
To adjust horizontally:
Loosen set
screw in top and bottom hinges with
Allen wrench. Determine the door
swing desired. Hold door in that
position and tighten the set screws.
The doors have stops at 90°, 115"
and 137" positions If the door
stops cannot be adjusted to clear
countertops, the countertops may
need to be mitered. (Consult your
builder to adjust countertops.)
To adjust vertically:
Loosen, do
not remove, top and bottom hinge
screws. Lift door and bottom hinge
to desired position. Tighten bottom
hinge screws and then top hinge
screws.
BEI Check the water
. connections at the
bottom of the refrigerator
again for leaking. Any leaking can
cause refrigerator and floor damage.
/171
Open both doors. Use
two screws to attach
n
bottom grille to cabinet
Loosen the four height adjustment
screws. Adjust the bottom grille to
fill the space from the floor to the
bottom of the cabinet. Tighten
adjustment screws
1181
Put shelves and bins
into the refrigerator and
n
freezer compartments.
Remove protective film from door
frame.
Move the ice maker arm
into the down position.
Set refrigerator and
freezer compartment controls to the
midpoint between 'COLD" and
"COLDEST". Check that the
compressor is operating properly.
Check that all five interior lights and
one exterior light above dispenser
area are working.
120
Use a drinking glass to
. press ice dispenser bar.
You should hear the
motor and auger operating. Press
the glass against the water
dispenser bar. Dispense and
discard 2 to 3 quarts of water to
remove air from system and
rinse tank.
To get the most efficient
use from your new
built-in refrigerator, read
your KitchenAid ' Use
and Care Guide. Keep
Ins talla tion Ins true tions
and Guide close to
built-in refrigerator for
easy reference.
Page 10