Fitting The Cutting Head - Husqvarna Rider 115C Operator's Manual

3 Check that the lever for setting the cutting height is in the
S position.
4 Put the lifting lever in the mowing position.
5 Release the clip and lift off the belt guard.
6 Disengage the spring for the drive belt tensioning wheel.
7 Lift of the drive belt.
8 Grip the top tubular construction of the unit and pull out
the unit until it stops.
9 Make sure the lock is in upright position.
Maintenance
10 Remove the pin in the equipment frame.
11 Loosen the stay from the cutting deck.
Pull out the cutting unit.
12 Lift off the deck and lean it against the machine or a wall.

Fitting the cutting head

1 Make sure the lock is in upright position.
2 Place the belt under the stay of the cutting deck.
– 21
English