Maintenance; Maintenance Schedule - Husqvarna Rider 115C Operator's Manual

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.

Maintenance

Cleaning
Check the engine's oil level
Check the engine's cooling air intake
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage.
Clean around the silencer
1)
Change engine oil
Check the cutting deck
Check the tyre pressures.
Lubricate joints and shafts
Check the V-belts
Checking and adjusting of throttle wire
2)
Replace the air filter .
Replace the fuel filter
Replace the spark plug.
Check the fuel hose. Replace if necessary .
1)
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every 25 hours.
and replace the filter more often in dusty conditions.
by authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be
!
conducted on the engine or cutting unit
unless:
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from
the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
16 –
English
Maintenance
3)
4)
3)
If the machine is used daily it should be lubricated twice a week.
Daily
At least once a
maintenance
year
before starting
X
X
X
X
X
X
X
O
O
O
O
Maintenance interval in
hours
25 50 100 200
X X
X
X
X
O
X
X
X
X
2)
Clean
4)
Conducted