Step 6 Position Water Line And House Wiring; Step 7 Install Drain Hose Through Cabinet; Step 8 Slide Dishwasher Partially Into Cabinet - GE Built-In Dishwasher Installation Instructions Manual

Installation Instructions
STEP 6 POSITION WATER LINE AND
HOUSE WIRING
• Position water supply line and house wiring on the fl oor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
House
Water
Wiring
Line
Figure M
STEP 7 INSTALL DRAIN HOSE THROUGH
CABINET
• Stand the dishwasher upright and position in front of the
opening. Insert drain hose into cabinet wall hole. If a power
cord is used, guide the end through a separate hole.
Drain Hose
Length 10"
Insulation
Blanket
Water
Power Cord
(If Used)
Figure N
TIP: Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
4"
6"
Maximum
Line
Drain
Hose
House
Wiring
STEP 8 SLIDE DISHWASHER PARTIALLY
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
Figure O
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a few
inches forward of adjacent cabinetry.
• Make sure drain hose is not kinked under the dishwasher and
there is no interference with the water line and wiring or any
other component.
7