Step 16 Dishwasher Wet Test; Step 17 Replace Toekick; Step 18 Literature - GE Built-In Dishwasher Installation Instructions Manual

Installation Instructions

STEP 16 DISHWASHER WET TEST

Turn on power supply (or plug power cord into outlet, Turn on power supply (or plug power cord into outlet,
■
if equipped).
Start the unit to check for leaks. Start the unit to check for leaks.
■
– Press ON/OFF button to turn unit on
– Press CYCLE SELECT button until light below RINSE cycle
illuminates
Close door. Close door.
■
Check to be sure that water enters the dishwasher. If water Check to be sure that water enters the dishwasher. If water
■
does not enter the dishwasher, check to be sure that water
and power are turned on.
Check for leaks under the dishwasher. If a leak is found, turn Check for leaks under the dishwasher. If a leak is found, turn
■
off power supply, then tighten connections. Restore power
after leak is corrected.
Check for leaks around the door. A leak around the door Check for leaks around the door. A leak around the door
■
could be caused by door rubbing or hitting against
adjacent cabinet. Reposition the dishwasher if necessary.
See Step 9.
The dishwasher will drain and turn off about 5 to 7 minutes The dishwasher will drain and turn off about 5 to 7 minutes
■
after the first fill. Check drain lines. If leaks are found,
turn power off at the breaker and correct plumbing as
necessary. Restore power after corrections are made. See
Step 12.
Open dishwasher door and make sure most of the water Open dishwasher door and make sure most of the water
■
has drained. If not, check that disposer plug has been
removed and/or air gap is not plugged. See Step 13. Also
check drain line for kinking.
Run the dishwasher through another fill and drain cycle. Run the dishwasher through another fill and drain cycle.
■
Check for leaks and correct if required.
At the end of drain, open door and press ON/OFF button to At the end of drain, open door and press ON/OFF button to
■
turn unit off.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225
ge.com

STEP 17 REPLACE TOEKICK

Use Top 4
Screw Holes
2 - P ie c e T o
e k ic k
Adjust Up
or Down
Figure HH
• Place 2-piece toekick against the legs of the dishwasher.
• Place the inner toekick piece (with slots) against the toekick
bracket. The slots should align with toekick bracket screw
holes. Allow the toekick to touch the fl oor.
• Place larger toekick over the inner piece and install 4 toekick
screws.
• Use additional 2 screws for installations over 33-1/2" high.
• Use both toekick pieces for all installation heights.

STEP 18 LITERATURE

• Be sure to leave complete literature package and Installation
Instructions with the consumer.
© 2005 General Electric Company
Pub. No. 31-30242
Dwg. No. 206C1559P180
ND 08C-2514 (4/08)