Table of Contents
Advertisement
3.
Replace battery cover.
REMOTE TEMPERATURE/HUMIDITY SENSOR
Note:
When changing the batteries in any of the units, all units need to be
reset by following the "Quick Set Up Guide" procedures. This is because
a random security code is assigned by the transmitter at start-up, and
this code must be received and stored by the intelligent weather station
in the first few minutes of power being supplied to it.
BATTERY CHANGE:
It is recommended to replace the batteries in all units on an annual
basis to ensure optimum accuracy of these units.
Please participate in the preservation of the environment.
Return used batteries to an authorized facility.
The remote temperature/humidity sensor uses 2 x AA
(alkaline recommended) batteries. To install and
replace the batteries, please follow the steps below:
1.
Remove the battery cover at the front side with a
small screwdriver.
2.
Insert the batteries, observing the correct polarity
(see battery compartment marking).
3.
Replace the battery cover on the unit.
The intelligent weather station uses 3 x
AA (alkaline recommended) batteries.
When the batteries need to be
replaced the low battery symbol will
appear on the LCD (or replace the
batteries annually). To install and
replace the batteries, please follow the
steps below:
1.
Remove the cover.
2.
Insert batteries observing the
correct polarity (see battery
compartment marking).
5
Hide quick links:
Advertisement
Table of Contents
