GE 5100 Series Owner's Manual page 13

Power Connection
Chart
230/208 Volt
Universal Power
Cord Kits
RAK315
RAK320
RAK330*
230/208 Volt
Permanent
Connection Kits
RAK415/415L
RAK420/420L
RAK430/430L*
Kits ending in "L" have flexible conduit to reach from the kit to the knockout hole
(above right side inspection plate) in the RAK203 sub-base.
265 Volt
Permanent
Connection Kits
RAK515/515LF
RAK517/517LF
RAK520/520LF
RAK530/530LF*
Kits ending in "LF" have flexible conduit to reach from the kit to the knockout hole
(above right side inspection plate) in the RAK203 Sub-Base and have an Integral Fuse.
*Not recommended for use on 6000 BTUH units. (If this connection kit is used it will provide a maximum
heat of 3.45 KW at 230 volts and 3.7 KW at 265 volts.)
Install the Wall Case
and Exterior Grille
Protective
panel
Slit
Stiffener
Wall Plug
Configuration
Tandem
Perpendicular
Large Tandem
Circuit Protective Device
15 Amp TD fuse or breaker
20 Amp TD fuse or breaker
30 Amp TD fuse or breaker
Circuit Protective Device
15 Amp TD fuse
15 Amp TD fuse
20 Amp TD fuse
30 Amp TD fuse
1 The RAB71 or RAB77 wall case
must be properly installed per
instructions packed with the case.
2 Remove the corrugated stiffener
and the outdoor protective
panel. Use the slit in the out-
door panel as a handhold and
push out.
3 Install the exterior grille from
the room side following instruc-
tions packed with the grille.
Circuit Protective Device
15 Amp TD fuse or breaker
20 Amp TD fuse or breaker
30 Amp TD fuse or breaker
Heater Wattage
@ 230/208 Volts
2.55/2.09 KW
3.45/2.82 KW
5.00/4.10 KW
Heater Wattage
@ 265 Volts
1.70 KW
3.00 KW
3.70 KW
5.00 KW
Heater Wattage
@ 230/208 Volts
2.55/2.09 KW
3.45/2.82 KW
5.00/4.10 KW
Insulated Wall Case
This chassis is designed to be
installed in an insulated wall case.
This minimizes condensation
from forming on the room side
of the case.
The RAB71 wall case is insulated.
Insulation kit RAK901L is available
for use with RAB77 or existing
uninsulated wall cases when
needed.
13