GE 5100 Series Owner's Manual page 12

Installation Instructions
230/208 Volt
Electrical Supply
T T a a n n d d e e m m
15 Amp.
P P e e r r p p e e n n d d i i c c u u l l a a r r
20 Amp.
L L a a r r g g e e T T a a n n d d e e m m
30 Amp.
Electrical wiring wall outlets
230/208 volts.
265 Volt
Electrical Supply
Inner conductors
Electrical
junction
box
Wire nut
Mounting
plate
Power
supply
Cover plate
conductors
with screws
12
A power connection kit must be
used to supply power to the
Zoneline unit. The appropriate kit
is determined by the voltage, the
means of electrical connection and
the amperage of the branch circuit.
Connections of 208 or 230 volt
circuits may be with a universal
power cord kit or a permanent
connector kit.
All wiring, including installation of
the receptacle, must be in accor-
dance with the NEC and local
codes, ordinances and regulations.
All 265V units must be direct-
connected using a universal
power connector kit.
The electrical rating marked on
the Zoneline must not exceed the
supply branch circuit.
The unit provides for the connec-
tion of 1 2 trade-size electrical
conduit and provision for connec-
tion to a wiring system in accor-
dance with the NEC, ANSI/NFPA
No. 70-1993. The NEC prohibits
connecting this unit with a flexible
power cord.
Universal
power cord
kit
OR
Permanent
connector
kit
Typical universal power
connector kits
How to Connect
1 Remove the room cabinet.
2 Install the power connector kit
per instructions in the kit.
3 Reinstall the room cabinet.