Ford Edge Owner's Manual page 170

170 Universal Garage Door Opener
4. Press and release the Genie Intellicode 2 transmitter's previously
programmed button. Both LED's on the garage door opener motor unit
should now flash purple.
5. Press and hold the previously programmed HomeLink button for two
seconds. Repeat this step up to three times until the garage door moves.
At this point programming is complete.
Clearing a HomeLink device
To erase programming from the three HomeLink buttons press and hold
the two outer HomeLink buttons until the indicator light begins to flash.
The led will begin flashing in 10 to 20 seconds, at which time both
buttons should be released. Programming has now been erased, and the
led should blink slowly to indicate the device is in train mode when any
of the three HomeLink buttons are pressed.
FCC and RSS-210 Industry Canada Compliance
This device complies with Part 15 of the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to your device not expressly approved by the
party responsible for compliance can void the user's authority to operate
the equipment.
2013 Edge (edg)
Owners Guide gf, 1st Printing
USA (fus)