How To Load Documents (For Ix500, S1500, S1500M, Or S510M) - Fujitsu ScanSnap SV600 Basic Operation Manual

How to Load Documents (For iX500, S1500, S1500M,
or S510M)
Load documents in the ScanSnap in the following procedure.
For details about documents that can be loaded, refer to
S1500, S1500M, or S510M)" (page
1.
If you are loading multiple sheets, check the number of sheets.
The maximum number of sheets in the ScanSnap is as follows:
For A4 or smaller sizes: Up to 50 sheets can be loaded (with paper weight of 80 g/m
and thickness of the document stack under 5 mm [0.2 in.]).
ATTENTION
If you try to scan more than the maximum amount that can be loaded, the following problems
may occur:
l Files cannot be properly created due to excessive file size.
l Paper jams occur during scanning.
2.
Fan the documents.
1. Hold both ends of the documents and fan them a few times.
2. Rotate the documents 90 degrees and fan them in the same manner.
3.
Straighten the edges of the documents and slightly displace the top edges at
an angle.
At an Angle
Feed Direction
ATTENTION
Paper jams or damage to documents may occur if you scan the documents without aligning the
edges first.

How to Load Documents (For iX500, S1500, S1500M, or S510M)

"Documents for Scanning (For iX500,
138).
144
2
[20 lb]