Scan In Tv Channels - Bang & Olufsen BeoVision 7 Manual

26
Select video signal type
If you have selected 'TV TUNER' in the
'TUNER SETUP' menu, enter the source of
your TV video signal.
Identify the cable box
If you have connected a cable box to the TV,
register the connection in the 'CABLE BOX
SETUP' menu.
Source for RF input
When you have registered the cable box,
enter the output channel for the type of
cable box and test whether you can change
channels.
Useful hints
1
*Signal type If you select 'CABLE' or 'ANTENNA', scanning begins immediately. If you
select 'CABLE BOX', register the cable box. See 'Identify the cable box'
on this page.
RF cable box Leave a connected RF cable box switched on at all times.
2
*Channel number The channel number should correspond to the output channel set on the
cable box.

Scan in TV channels

Find out how to register the source of your TV signal type and how to scan in
your TV channels.
Bring up 'TV SETUP' Highlight 'TV
menu and select TUNER' in 'TUNER
'OPTIONS' SETUP' menu
Select name of cable box
Select channel
Select 'CH TEST'
2
number*
Select signal type Scanning begins/
and accept identify cable box*
Test if you can Store or repeat
change channel procedure
NOTE! If you select 'OFF' for 'TV TUNER', you
must register a source in the 'CONNECTIONS'
menu as 'TV' if you wish to switch on the TV
using the TV button on the remote control. See
'Register additional equipment' on p. 43.
1