IBM DTTA-351010 - Deskstar 10.1 GB Hard Drive Specifications page 53

Figure 39. Power Supply Current of DTTA-351010/350840/350640/350430/350320
(All values in Amps.)
Idle Average
Idle ripple (peak-to-peak)
Seek peak
Seek average (*1)
Start up (max)
R N D R/W peak
R N D R/W average (*2)
Standby/Sleep average
Notes:
1. Random Seeks at 40% duty cycle.
2. Seek Duty = 30%, W/R Duty = 45%, Idle Duty = 25%.
Figure 40. Power Supply Generated Ripple as seen at file power connector
+ 5 V DC
+ 1 2 V DC
During file start up and seeking, 12 volt ripple is generated by the file (referred to as dynamic loading). If
several files have their power daisy chained together then the power supply ripple plus other file's dynamic
loading must remain within the above regulation tolerance. A common supply with separate power leads to
each file is a more desirable method of power distribution.
To prevent external electrical noise from interfering with the file's performance, the file must be held by four
screws in a user system frame which has no electrical level difference at the four screws position, and has less
than + / - 3 0 0 millivolts peak to peak level difference to the file power connector ground.
+5Volts
Pop Mean Std.Dev
0.29 0.02
0.22 0.04
0.5 0.02
0.33 0.02
0.7 0.02
0.6 0.15
0.42 0.15
0.165 0.01
Maximum
100 [ mV pp]
150 [ mV pp]
+12Volts
Pop Mean Std.Dev
0.16 0.05
0.3 0.1
1.23 0.2
0.37 0.1
1.2 0.1
0.38 0.1
0.34 0.1
0.0045 0.001
Notes
0-10 [ MHz]
0-10 [ MHz]
Total
(W)
3.4
6.1
6.2
0.9
45
Specification