Interface Capability For Power Modes; Function; Attributes; Attribute Values - IBM DTLA-305040 - Deskstar 41.1 GB Hard Drive Specifications

10.5.4 Interface capability for power modes

Each power mode affects the physical interface as defined in the following table.
Mode
Active
Idle
Standby
Sleep

Figure 77. Power conditions

Ready (RDY) is not a power condition. A device may post ready at the interface even though the media
may not be accessible.
10.6 S.M.A.R.T. function
The intent of Self-Monitoring Analysis and Reporting Technology (S.M.A.R.T) is to protect user data and
prevent unscheduled system downtime that may be caused by predictable degradation and/or fault of the
device. By monitoring and storing critical performance and calibration parameters, S.M.A.R.T devices
employ sophisticated data analysis algorithms to predict the likelihood of near-term degradation or fault
condition. By alerting the host system of a negative reliability status condition, the host system can warn
the user of the impending risk of a data loss and advise the user of appropriate action.

10.6.1 Attributes

Attributes are the specific performance or calibration parameters that are used in analyzing the status of
the device. Attributes are selected by the device manufacturer based on the ability of that attribute to
contribute to the prediction of degrading or faulty conditions for that particular device. The specific set of
attributes being used and the identity of these attributes is vendor specific and proprietary.

10.6.2 Attribute values

Attribute values are used to represent the relative reliability of individual performance or calibration attri-
butes. The valid range of attribute values is from 1 to 253 decimal. Higher attribute values indicate that
the analysis algorithms being used by the device are predicting a lower probability of a degrading or faulty
condition existing. Accordingly, lower attribute values indicate that the analysis algorithms being used by
the device are predicting a higher probability of a degrading or faulty condition.

10.6.3 Attribute thresholds

Each attribute value has a corresponding attribute threshold limit which is used for direct comparison to
the attribute value to indicate the existence of a degrading or faulty condition. The numerical values of the
attribute thresholds are determined by the device manufacturer through design and reliability testing and
analysis. Each attribute threshold represents the lowest limit to which its corresponding attribute value
can be equal while still retaining a positive reliability status. Attribute thresholds are set at the device
manufacturer's factory and cannot be changed in the field. The valid range for attribute thresholds is from
1 through 253 decimals.
BSY RDY
X X
O 1
O 1
O 1
Deskstar 40GV & 75GXP hard disk drive specifications
Interface
active
Yes
Yes
Yes
No
81
Media
Active
Active
Inactive
Inactive