Standby (E2H/96H); Figure 139. Standby Command (E2H/96H) - IBM DTLA-305040 - Deskstar 41.1 GB Hard Drive Specifications

12.33 Standby (E2h/96h)

Command Block Output
Registers
Register
Data
Feature
Sector Count
Sector Number
Cylinder Low
Cylinder High
Device/Head
Command
Error Register
7 6 5
CRC UNC 0
0 0 0

Figure 139. Standby Command (E2h/96h)

The Standby command causes the device to enter the Standby Mode immediately and to set the auto
power down time-out parameter (standby timer).
When the Standby mode is entered, the drive is spun down but the interface remains active. If the drive is
already spun down, the spin down sequence is not executed.
During the Standby mode the drive will respond to commands but there is a delay while waiting for the
spindle to reach operating speed.
The automatic power down sequence is enabled and the timer starts counting down when the drive re-
turns to Idle mode.
7 6 5 4 3 2 1 0
- - - - - - - -
- - - - - - - -
V V V V V V V V
- - - - - - - -
- - - - - - - -
- - - - - - - -
1 - 1 D - - - -
1 1 1 0 0 0 1 0
4 3 2 1 0
IDN 0 ABT T0N AMN
0 0 V 0 0
Deskstar 40GV & 75GXP hard disk drive specifications
Command Block Input
Registers
Register
Data
Error
Sector Count
Sector Number
Cylinder Low
Cylinder High
Device/Head
Status
Status Register
7 6 5 4
BSY RDY DF DSC
0 V 0 V
179
7 6 5 4 3 2 1 0
- - - - - - - -
see below
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
- - - - - - - -
see below
3 2 1 0
DRQ COR IDX ERR
– 0 – V