Automatic Operation; Ambient Switch - Hyundai Elantra Owner's Manual

B970C02E-AAT

Automatic Operation

The FATC (Full Automatic Temperature Con-
trol) system automatically controls heating and
cooling as follows:
1. Push the "AUTO" switch. The indicator light
will illuminate confirming that the Face, Floor
and/or Bi-Level modes as well as the blower
speed and, air conditioner will be controlled
automatically.
FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI
2. Push the "TEMP" button to set the desired
HXD118D
temperature.
The temperature will increase to the maxi-
mum 90°F(32°C) by pushing on the
Each push of the button will cause the
temperature to increase by 1°F(0.5°C).
The temperature will decrease to the mini-
mum 62°F(17°C) by pushing on the
Each push of the button will cause the
temperature to decrease by 1°F(0.5°C).
NOTE:
If the battery has been discharged or dis-
connected, the temperature mode will reset
to centigrade degrees.
This is a normal condition and you can
change the temperature mode from centi-
grade to farenheit as follows;
Press the TEMP button down 3 seconds or
more with the OUTSIDE
display shows that the unit of temperature
is adjusted to contigrade or fahrenheit.
(°C °F or °F
HXD118A
button.
button.
button held down. The
TEMP
°C)
Photo sensor
NOTE:
Never place anything over the sensor which
is located on the instrument panel to ensure
better control of the heating and cooling
system.
B995A01Y-GAT

AMBIENT SWITCH

G280A01E
HXD118I
1- 61