Alarm Stage; Disarmed Stage; Keyless Entry System; Unlocking Doors - Hyundai Elantra Owner's Manual

After completion of the steps above, the turn
signal lights will blink once to indicate that the
system is armed.
NOTE:
1) If any door, trunk lid (4 door)/ tail gate
(5 door) or engine hood remains open, the
system will not be armed.
2) If this happens, rearm the system as
described above.
3) Once the system is armed, only the trunk
lid (4 door) may be unlocked using the
key without disarming the system.
CAUTION:
Do not arm the system until all passengers
have left the car. If the system is armed
while a passenger(s) remains in the car, the
alarm may be activated when the remaining
passenger(s) leaves the car.
B070C02E-AAT

Alarm Stage

The alarm will be activated if any of the follow-
ing occurs while the car is parked and the
system is armed.
1) A door and tail gate (5 door) are opened
without using the transmitter.
2) The trunk lid (4 door) is opened without
using the key.
3) The engine hood is opened.
FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI
FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI FEATURES OF YOUR HYUNDAI
The siren will sound and the turn signal light will
blink continuously for 30 seconds (This hap-
pens 3 times). To turn off the system, unlock
the door or tail gate (5 door) with the transmitter.
CAUTION:
Avoid trying to start the engine while the
system is armed.
B070D02E-AAT

Disarmed Stage

The system will be disarmed when the following
step is taken:
The driver's or passenger's door is unlocked by
depressing the "UNLOCK" button on the trans-
mitter.
After completion of the step above, the turn
signal lights will blink twice to indicate that the
system is disarmed.
NOTE:
Once the system has been disarmed, it can
not be rearmed except by repeating the
arming procedures.
CAUTION:
Only the transmitter can disarm the armed
stage. If the transmitter does not disarm the
system, it is necessary to take the following
steps;
1. Unlock the door with the key, which will
cause, the alarm to be activated.
2. Insert the key in the ignition key cylinder
and turn the ignition key to "ON" position.
3. Wait for 30 seconds.
After completing the steps above, the sys-
tem will be disarmed.
B070F01A-GAT
Keyless Entry System (If Installed)
Locking doors
1. Close all doors.
B070D01E
2. Push the "LOCK" button on the transmitter.
3. At the same time all doors lock, the turn
signal light will blink once to indicate that the
system is armed.

Unlocking doors

1. Push the "UNLOCK" button on the transmit-
ter.
2. At the same time all doors unlock, the turn
signal light will blink twice to indicate that the
system is disarmed.
1- 5