Operation - Dimplex DF2600 Service Manual

OPERATION

Figure 1
C
B
The controls are located on the upper right of the fireplace.
(Figure 1)
A. 3-Position Switch
The switch has two ON positions marked with " I " and " II "
. The " I " position is for manual operation. In this position
the built-in remote control is by-passed.
The " II " position is for operating the unit with the provided
remote control.
When in the " II " position the unit is operated with the ON
and OFF buttons of the remote control. When the switch is
in the center position the unit is off.
B. Heater ON/OFF Switch
The Heater ON/OFF Switch supplies power to the heater
fan and the heater element. When the switch is in the ON
position the heater operates if the thermostat calls for heat.
! NOTE: The fan will continue running even when the
heater is not, when the Heater Switch is in the ON position.
C. Heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to turn on
the heater. When the room reaches the desired temper-
ature, turn the thermostat knob counter clockwise until you
hear a click. Leave in this position to maintain the room
temperature at this setting. For additional heat, turn clock-
wise until you hear the click again and the heater will turn
on.
Resetting The Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without being
reset. It can be reset by switching the 3-Position Switch to
OFF and waiting 5 minutes before switching the unit back
on.
CAUTION: If you need to continuously reset the heater,
unplug the unit and call technical support at 1-888-346-
7539.
! NOTE: The heater may emit a slight, harmless odor
when first used. This odor is a normal condition caused
by initial heating of internal heater parts and will not occur
again.
Remote Operation
The fireplace is supplied with an integrated On/Off
control.
!
to the remote control setting, "II". To operate, push the ON
A
button to turn fireplace on, push the OFF button to turn the
fireplace
!
control, pull the plastic insulator strip out from between the
remote casing and battery cover (Figure 5).
Remote Control Initialization/Reprogram
In the event that your remote control ceases to operate
your fireplace, follow these steps to reinitialize the remote
control and the remote control receiver in the fireplace:
1. Place the 3-Position Switch (Figure 1A) in the OFF
2. Wait a minimum of 5 seconds and then place the 3-Po-
3. Within 10 seconds of changing the switch position,
! NOTE: You will have only 10 seconds to perform this
last step. Failure to do so will result in these steps needing
to be followed again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on the remote control (Figure
2. Correctly install one 12 Volt (A23) battery in the battery
3. Close the battery cover.
NOTE: Ensure that the fireplace 3 position switch is set
off.
NOTE: Before attempting any operation with the remote
("O") position.
sition Switch in the Remote Control position.
press the ON button located on the remote control
(Figure 2). This will synchronize the remote control and
the fireplace receiver.
2).
holder.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for recyc-
ling advice in your area
Figure 2
ON
Button
OFF
Button
Plastic Strip
remote
Battery Cover
3