Dimplex DF2608 Owner's Manual
Hide thumbs
Also See for DF2608:
- Owner's manual (63 pages) ,
- Practical user's manual (20 pages) ,
- Service manual (18 pages)
Table of Contents
Advertisement
Quick Links
IMPORTANT SAFETY INFORMATION: Always read this manual irst
before attempting to install or use this ireplace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
Owner's Manual
Model
DF2608
NBDF2608
DF2622
7208680100R07
Advertisement
Table of Contents
Related Manuals for Dimplex DF2608
Summary of Contents for Dimplex DF2608
- Page 1 For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7208680100R07...
-
Page 2: Table Of Contents
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of ire, serious injury, or death. www.dimplex.com... -
Page 3: Welcome & Congratulations
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric ireplace from Dimplex, the world leader in electric ireplaces. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, ire hazard and will void the warranty. -
Page 4: Important Instructions
⑭ Do not modify the electric the electric ireplace has been ireplace. Use it only as described dropped or damaged in any man- in this manual. Any other use not ner, contact Dimplex Technical www.dimplex.com... -
Page 5: Save These Instructions
IMPORTANT INSTRUCTIONS recommended by the manufactur- ㉑ When transporting or storing er may cause ire, electric shock the unit and cord, keep in a dry or injury to persons. place, free from excessive vibra- tion and store so as to avoid dam- ⑮... - Page 6 Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. www.dimplex.com...
-
Page 7: Fireplace Installation
Fireplace Installation liquids in the vicinity of the heater. WARNING: Ensure the power cord is not installed so that it is Clearance for air CAUTION: pinched or against a sharp edge circulation beneath the ire- and ensure that the power cord is place insert is provided by two stored or secured to avoid tripping rubber feet. -
Page 8: Fireplace Assembly
3. Using side cutters or scis- Install the ireplace into the sors, cut and remove the two mantel (refer to mantel assembly cable ties as shown in Figure instructions). 2 and remove the cardboard IMPORTANT: If not using a www.dimplex.com... -
Page 9: New Wall Construction
9” may exceed the current rating (229 mm) of the circuit breaker. Dimplex mantel, the ireplace must be installed in an enclosure Existing Fireplace with the following minimum inter- 1. Seal all drafts and vents with... - Page 10 Do not partially or fully cover or ob- struct the front of this heater. Wiring 3-POSITION SWITCH RECEIVER REMOTE UPPER LOWER LIGHTS LIGHTS MANUAL DRIVER DIMMER HEATER ON/OFF SPEED CONTROL CUT-OUT LOGS BLOWER MOTOR ELEMENTS FLICKER MOTOR THERMOSTAT www.dimplex.com...
-
Page 11: Operation
Operation Figure 5 the desired level. WARNING: This electric irebox must be properly installed C. Light Dimmer Control before it is used. Turn the Light Dimmer Control knob to increase or decrease the Manual Controls The manual controls for the brightness of the interior of the ireplace. - Page 12 Button CAUTION: If you need to con- tinuously reset the heater, un- Button plug the unit and call Technical Support at 1-888-346-7539. Plastic Please have your model and strip serial number ready when call- ing. Battery cover www.dimplex.com...
- Page 13 Operation step. Failure to do so will Remote Control Initialization/ Reprogramming result in these steps needing to be followed again. Follow these steps for remote control initialization and if re- This will synchronize the remote quired, re-initialization: control and receiver. 1.
-
Page 14: Maintenance
LED’s and unit, as this can cause a build up wires (DF2608 only). of heat and eventual damage. For CAUTION: Allow at least ive this reason the heater must be... - Page 15 Maintenance Figure 7 Figure 8 Ember Bed Back Trim Ledge Rear Front Log Set Glass Assembly Side Section Front Edge ber bed or plastic grate. and licker rod. NOTE: Log set assembly its 13. Install the log set assembly by tightly into irebox, some force placing the front, bottom edge may be necessary to remove.
- Page 16 5. Slide glass to the right side and attach trim. of the ireplace to remove (Figure 7). Figure 9 Light Block screws (4) Light Block Flicker Rod Light Filter Bracket screws (2) Lower Light Bulbs (3) www.dimplex.com...
-
Page 17: Warranty
Subject to Territories or in any of the 50 States of the USA (and the District of Columbia) except the provisions of this warranty, Dimplex for Hawaii and Alaska. This limited war- warrants such products to be free from... - Page 18 12:01 a.m. on the day after the irst anniversary of the What Dimplex will do in the event of a irst purchase and ending at mid- defect night on the second anniversary of...
- Page 19 FORESEEABLE. IN NO EVENT WILL the irst anniversary of the date of DIMPLEX, OR ITS OFFICERS, DIREC- irst purchase, Dimplex will in its sole TORS, OR AGENTS BE LIABLE FOR discretion either repair or replace such ANY DIRECT LOSSES, COSTS, OR...
-
Page 20: Replacement Parts
Replacement Parts LED Log Set (DF2608, NBDF2608) ....0439560100RP Log Set (DF2622) ....... . .
Need help?
Do you have a question about the DF2608 and is the answer not in the manual?
Questions and answers